Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
guides:elektrosluchminicity [2016/11/02 16:57] – mrkva | guides:elektrosluchminicity [2017/10/02 16:13] – mrkva | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Building Elektrosluch Mini City ====== | ====== Building Elektrosluch Mini City ====== | ||
+ | //Updated 2. 10. 2017: Step 17// | ||
{{: | {{: | ||
Line 11: | Line 12: | ||
[[http:// | [[http:// | ||
+ | You can check the [[https:// | ||
===== Required tools ===== | ===== Required tools ===== | ||
Line 58: | Line 60: | ||
<WRAP half column> | <WRAP half column> | ||
- | 6. **Solder in the four polymer capacitors.** Beware of their polarity, minus (-) is marked | + | 6. **Solder in the four polymer capacitors.** Beware of their polarity, minus (-) is marked |
</ | </ | ||
Line 107: | Line 109: | ||
<WRAP half column> | <WRAP half column> | ||
- | 13. (Optional) | + | 13. Cover the battery with attached LOM sticker. |
- | 14. **Check one more time if all the polarities (capacitors, | + | \\ |
+ | 14. **Check one more time if all the polarities (capacitors, | ||
</ | </ | ||
Line 122: | Line 125: | ||
<WRAP half column> | <WRAP half column> | ||
- | 15. Put the **knob** on the potentiometer. It requires a bit of pressure, make sure you're holding the pot and pressing it against it, not against the whole device.</ | + | 15. Put the **knob** on the potentiometer. It requires a bit of pressure, make sure you're holding the pot and pressing it against it, not against the whole device. |
+ | |||
+ | **Check whether the LED lights up.** Plug-in your headphones, turn the potentiometer almost all the way up and **listen if you can hear the buzzing and humming of the electricity** around you from both channels.</ | ||
</ | </ | ||
Line 129: | Line 134: | ||
<WRAP half column> | <WRAP half column> | ||
- | 16. Attach the **front cover** using the 8 screws and 4 stand-offs.</ | + | 16. Attach the **front cover** using the 8 screws and 4 stand-offs. The front cover has a plastic film on both sides for protection – peel it off for more shiny look!</ |
+ | </ | ||
+ | |||
+ | <WRAP group> | ||
+ | <WRAP half column> | ||
+ | |||
+ | <WRAP half column> | ||
+ | 17. Eleketrosluch Mini City kits shipped at the end of September 2017 and onwards have **extra acrylic cover** for the bottom of the circuit board. Attach it as pictured.</ | ||
</ | </ | ||
<WRAP group> | <WRAP group> | ||
- | <WRAP half column> | + | <WRAP half column> |
<WRAP half column> | <WRAP half column> | ||
- | 17. **Voilá!** Enjoy your new Elektrosluch!</ | + | 18. **Voilá!** Enjoy your new Elektrosluch!</ |
</ | </ |