Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
guides:geofon [2023/09/19 18:26] – mrkva | guides:geofon [2023/09/19 23:28] – mrkva | ||
---|---|---|---|
Line 8: | Line 8: | ||
If you never soldered before, we highly recommend watching these videos before you start with the kit. | If you never soldered before, we highly recommend watching these videos before you start with the kit. | ||
[[http:// | [[http:// | ||
+ | |||
<WRAP group> | <WRAP group> | ||
<WRAP half column> | <WRAP half column> | ||
Line 18: | Line 19: | ||
* Neutrik XLR connector | * Neutrik XLR connector | ||
* a stainless steel spike with an extender (in the tube) | * a stainless steel spike with an extender (in the tube) | ||
- | * a suction cup</ | + | * a suction cup |
+ | </ | ||
<WRAP half column> | <WRAP half column> | ||
Line 26: | Line 28: | ||
* solder (0.75 mm or 1 mm, lead-free) | * solder (0.75 mm or 1 mm, lead-free) | ||
* 2.5 mm Allen (hex) key | * 2.5 mm Allen (hex) key | ||
- | * 14 mm wrench (optional)</ | + | * 14 mm wrench (optional) |
+ | </ | ||
</ | </ | ||
Line 47: | Line 50: | ||
<WRAP half column> | <WRAP half column> | ||
- | 3. older the provided XLR connector to the cable. You'll notice it has small number markings. Solder the exposed conductor with heat-shrink tubing to pin number 1, the brown conductor to pin 2, and the white conductor to pin 3. The heat-shrink tubing will shrink as you solder the shielding conductor. If you're not satisfied with the amount of shrinkage, you can use a lighter or a heat gun to ensure it shrinks fully. | + | 3. Solder |
//Technical note: The Geofón is connected as a true balanced microphone, resulting in the exceptional low noise.// | //Technical note: The Geofón is connected as a true balanced microphone, resulting in the exceptional low noise.// | ||
Line 77: | Line 80: | ||
<WRAP half column> | <WRAP half column> | ||
- | 7. Solder the conductors to the pins on the element. Brown conductor should be connected to the pin with a dot next to it.</ | + | 7. Solder the conductors to the pins on the element. Brown conductor should be connected to the pin with a dot next to it. Solder as fast as possible, one joint shouldn' |
<WRAP group> | <WRAP group> | ||
Line 90: | Line 93: | ||
<WRAP half column> | <WRAP half column> | ||
- | 9. Screw the bottom part of the Geofón body onto the top part, and tighten | + | 9. Screw the bottom part of the Geofón body onto the top part. Tighten |
<WRAP group> | <WRAP group> |