Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
Last revisionBoth sides next revision
guides:geofon [2023/09/19 23:28] – mrkvaguides:geofon [2024/03/19 12:21] – mrkva
Line 18: Line 18:
   * a heat-shrink tubing (in the tube)   * a heat-shrink tubing (in the tube)
   * Neutrik XLR connector   * Neutrik XLR connector
 +  * a neodymium magnet (attached to the body)
   * a stainless steel spike with an extender (in the tube)   * a stainless steel spike with an extender (in the tube)
   * a suction cup   * a suction cup
Line 50: Line 51:
  
 <WRAP half column>  <WRAP half column> 
-3. Solder the provided XLR connector to the cable. You'll notice it has small number markings. Solder the exposed conductor with heat-shrink tubing to pin number 1, the brown conductor to pin 2, and the white conductor to pin 3. +3. Tin the exposed conductors on the cable with a bit of solder. Check the XLR connector — you'll notice it has small number markings. Solder the exposed conductor with heat-shrink tubing to pin number 1, the brown conductor to pin 2, and the white conductor to pin 3. 
  
 The heat-shrink tubing will shrink as you solder the shielding conductor. If you're not satisfied with the amount of shrinkage, you can use a lighter or a heat gun to ensure it shrinks fully. The heat-shrink tubing will shrink as you solder the shielding conductor. If you're not satisfied with the amount of shrinkage, you can use a lighter or a heat gun to ensure it shrinks fully.
Line 70: Line 71:
  
 <WRAP half column>  <WRAP half column> 
-5. Unscrew the Geofón body parts apart and remove the Geofón element from inside.</WRAP></WRAP>+5. Unscrew the Geofón body parts apart and remove the Geofón element from inside.  
 + 
 +Note: newer version of the Geofón body may have threads swapped between top and bottom part compared to the picture.</WRAP></WRAP>
  
 <WRAP group> <WRAP group>
Line 82: Line 85:
  
 <WRAP half column>  <WRAP half column> 
-7. Solder the conductors to the pins on the element. Brown conductor should be connected to the pin with a dot next to it. Solder as fast as possible, one joint shouldn't take longer then 2-4 seconds (depending on your soldering iron).</WRAP></WRAP>+7. Tin the exposed conductors on the cable with a bit of solder. Solder the conductors to the pins on the element. Brown conductor should be connected to the pin with a dot next to it. Solder as fast as possible, one joint shouldn't take longer then 2-4 seconds (depending on your soldering iron). 
 + 
 +<WRAP center round tip 60%> 
 +It helps to temporarily place a piece of paper on top of the element (pierce it through the pins) to prevent solder from sticking to the metallic ring around them. 
 +</WRAP> 
 + 
 +</WRAP></WRAP>
  
 <WRAP group> <WRAP group>