Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
Last revisionBoth sides next revision
guides:geofon [2023/11/01 16:55] – mrkvaguides:geofon [2024/03/19 12:21] – mrkva
Line 71: Line 71:
  
 <WRAP half column>  <WRAP half column> 
-5. Unscrew the Geofón body parts apart and remove the Geofón element from inside.</WRAP></WRAP>+5. Unscrew the Geofón body parts apart and remove the Geofón element from inside.  
 + 
 +Note: newer version of the Geofón body may have threads swapped between top and bottom part compared to the picture.</WRAP></WRAP>
  
 <WRAP group> <WRAP group>
Line 83: Line 85:
  
 <WRAP half column>  <WRAP half column> 
-7. Tin the exposed conductors on the cable with a bit of solder. Solder the conductors to the pins on the element. Brown conductor should be connected to the pin with a dot next to it. Solder as fast as possible, one joint shouldn't take longer then 2-4 seconds (depending on your soldering iron).</WRAP></WRAP>+7. Tin the exposed conductors on the cable with a bit of solder. Solder the conductors to the pins on the element. Brown conductor should be connected to the pin with a dot next to it. Solder as fast as possible, one joint shouldn't take longer then 2-4 seconds (depending on your soldering iron). 
 + 
 +<WRAP center round tip 60%> 
 +It helps to temporarily place a piece of paper on top of the element (pierce it through the pins) to prevent solder from sticking to the metallic ring around them. 
 +</WRAP> 
 + 
 +</WRAP></WRAP>
  
 <WRAP group> <WRAP group>