Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
guides:geofon [2023/11/01 16:55] – mrkvaguides:geofon [2024/03/19 12:22] (current) – mrkva
Line 71: Line 71:
  
 <WRAP half column>  <WRAP half column> 
-5. Unscrew the Geofón body parts apart and remove the Geofón element from inside.</WRAP></WRAP>+5. Unscrew the Geofón body parts apart and remove the Geofón element from inside.  
 + 
 +Note: newer version of the Geofón body may have threads swapped between top and bottom part, compared to the picture.</WRAP></WRAP>
  
 <WRAP group> <WRAP group>
Line 83: Line 85:
  
 <WRAP half column>  <WRAP half column> 
-7. Tin the exposed conductors on the cable with a bit of solder. Solder the conductors to the pins on the element. Brown conductor should be connected to the pin with a dot next to it. Solder as fast as possible, one joint shouldn't take longer then 2-4 seconds (depending on your soldering iron).</WRAP></WRAP>+7. Tin the exposed conductors on the cable with a bit of solder. Solder the conductors to the pins on the element. Brown conductor should be connected to the pin with a dot next to it. Solder as fast as possible, one joint shouldn't take longer then 2-4 seconds (depending on your soldering iron). 
 + 
 +<WRAP center round tip 60%> 
 +It helps to temporarily place a piece of paper on top of the element (pierce it through the pins) to prevent solder from sticking to the metallic ring around them. 
 +</WRAP> 
 + 
 +</WRAP></WRAP>
  
 <WRAP group> <WRAP group>