Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
laser [2016/09/14 17:15] – mrkva | laser [2016/09/23 01:17] – mrkva | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Laser ====== | ====== Laser ====== | ||
- | [[http:// | + | [[http:// |
+ | [[http:// | ||
**Generálne skúsenosti a nápady** | **Generálne skúsenosti a nápady** | ||
Line 7: | Line 8: | ||
* Automatický návrh krabičiek: [[http:// | * Automatický návrh krabičiek: [[http:// | ||
* [[https:// | * [[https:// | ||
+ | * [[https:// | ||
**Troubleshooting** | **Troubleshooting** | ||
Line 14: | Line 16: | ||
* https:// | * https:// | ||
* http:// | * http:// | ||
+ | |||
+ | **Parts** | ||
+ | * [[http:// | ||
+ | * [[http:// | ||
+ | * Chiller cw5200 | ||
**Témy** | **Témy** | ||
Line 25: | Line 32: | ||
* Set your corner power to 70% of your cut power. [[https:// | * Set your corner power to 70% of your cut power. [[https:// | ||
* Not to cut/etch anything that contains chlorine! | * Not to cut/etch anything that contains chlorine! | ||
+ | |||
+ | |||
+ | **Materiály** | ||
+ | * [[http:// | ||
+ | * [[http:// | ||
+ | * [[http:// | ||
+ | * [[http:// | ||
**Ideálne nastavenia pre materiály** | **Ideálne nastavenia pre materiály** | ||
Line 30: | Line 44: | ||
| MDF 2.5 mm | Rez | 80% | 7 | | | MDF 2.5 mm | Rez | 80% | 7 | | ||
| MDF 2.5 mm | Gravír | 30% | 100 | | | MDF 2.5 mm | Gravír | 30% | 100 | | ||
+ | | Kartón 0.5 mm | Rez | 50% | 30 | | ||