Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revisionLast revisionBoth sides next revision | ||
| research:diy_stereo_bar [2018/04/09 16:48] – mrkva | research:diy_stereo_bar [2018/04/09 16:58] – mrkva | ||
|---|---|---|---|
| Line 14: | Line 14: | ||
| {{: | {{: | ||
| - | - Adjust the size of the rail to your liking. For a 40 cm AB stereo bar I went with 42.5 cm | + | - Adjust the size of the rail to your liking. For a 40 cm AB stereo bar I went with 42.5 cm. |
| - | - Drill the three holes in the top rail. For 3/8" you can use 9mm drill bit on the sides and 10mm on the central one | + | - Drill the three holes in the top rail. For 3/8" you can use 9mm drill bit on the sides and 10mm on the central one. On the sides, the closer to the internal diameter of 3/8" you'll get, the better. |
| - | - Screw in the screws into the holes and use thumbwheels as washers, protecting the screws from falling out. Alternatively you can use M8 retaining rings for shafts | + | - Screw in the screws into the holes and use thumbwheels as washers, protecting the screws from falling out. Alternatively you can use M8 retaining rings for shafts. |
| - | - Use the third thumb wheel as a way to tighten the bar to your stand | + | - Use the third thumb wheel as a way to tighten the bar to your stand. |
| | | ||
| - | {{:research:img_1165.jpg? | + | {{:undefined:img_1168.jpg? |