Show pageOld revisionsBacklinksBack to top This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong. ====== DIY stereo bar (on budget) ====== **Ingredients:** * unperforated DIN rail (available in electrical supply stores) * 2 K&M 3/8" thumb screws (available on [[https://www.thomann.de/intl/km_raendelschraube.htm|Thomann]]) * 3 K&M 3/8" thumb wheel (available on [[https://www.thomann.de/intl/km_raendelscheibe_alu_sw.htm|Thomann]] **Tools:** * drill for making the holes in the rail * 9mm drill bit (but you can use a smaller one and extend it manually) {{:research:img_1163.jpg?nolink&600|}} - Adjust the size of the rail to your liking. For a 40 cm AB stereo bar I went with 42.5 cm - Drill the three holes in top the rail. For 3/8" you can use 9mm drill bit on the sides and 10mm on the central one - Screw in the screws into the holes and use thumbwheels as washers protecting the screws from falling out - Use the third thumb wheel as a way to tighten the bar to your stand {{:research:img_1165.jpg?nolink&600|}} . {{:research:img_1167.jpg?nolink&600|}} . {{:research:img_1166.jpg?nolink&600|}}