Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
research:diy_stereo_bar [2018/04/09 16:39] – mrkva | research:diy_stereo_bar [2018/04/09 17:08] (current) – mrkva | ||
---|---|---|---|
Line 2: | Line 2: | ||
**Ingredients: | **Ingredients: | ||
- | * unperforated DIN rail (available in electrical supply stores) | + | * unperforated, zinc-plated steel DIN rail (available in electrical supply stores |
* 2 K&M 3/8" thumb screws (available on [[https:// | * 2 K&M 3/8" thumb screws (available on [[https:// | ||
* 3 K&M 3/8" thumb wheel (available on [[https:// | * 3 K&M 3/8" thumb wheel (available on [[https:// | ||
Line 10: | Line 10: | ||
* 9mm drill bit (but you can use a smaller one and extend it manually) | * 9mm drill bit (but you can use a smaller one and extend it manually) | ||
- | {{:research: | + | **Total cost: ~6€** |
- | - Adjust the size of the rail to your liking. For a 40 cm AB stereo bar I went with 42.5 cm | + | {{: |
- | – Drill the three holes in top the rail. For 3/8" you can use 9mm drill bit on the sides and 10mm on the central one | + | |
- | – Screw in the screws into the holes and use thumbwheels as washers protecting the screws from falling out | + | |
- | – Use the third thumb wheel as a way to tighten the bar to your stand | + | |
+ | | ||
+ | | ||
| | ||
- | {{:research:img_1165.jpg? | + | {{:undefined:img_1168.jpg? |