Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
research:diy_stereo_bar [2018/04/09 16:56]
mrkva
research:diy_stereo_bar [2018/04/09 17:08] (current)
mrkva
Line 14: Line 14:
 {{:​research:​img_1163.jpg?​nolink&​800|}} {{:​research:​img_1163.jpg?​nolink&​800|}}
  
-  - Adjust the size of the rail to your liking. For a 40 cm AB stereo bar I went with 42.5 cm +  - Adjust the size of the rail to your liking. For a 40 cm AB stereo bar I went with 42.5 cm. 
-  - Drill the three holes in the top rail. For 3/8" you can use 9mm drill bit on the sides and 10mm on the central one +  - Drill the three holes in the top rail. For 3/8" you can use 9mm drill bit on the sides and 10mm on the central one. On the sides, the closer to the internal diameter of 3/8" you'll get, the better. 
-  - Screw in the screws into the holes and use thumbwheels as washers, protecting the screws from falling out. Alternatively you can use M8 retaining rings for shafts +  - Screw in the screws into the holes and use thumbwheels as washers, protecting the screws from falling out. Alternatively you can use M8 retaining rings for shafts. 
-  - Use the third thumb wheel as a way to tighten the bar to your stand+  - Use the third thumb wheel as a way to tighten the bar to your stand. You can epoxy-glue the wheel to the bar to attach it permanently.
   ​   ​
 {{:​undefined:​img_1168.jpg?​nolink&​600|}} . {{:​research:​img_1167.jpg?​nolink&​600|}} . {{:​research:​img_1166.jpg?​nolink&​600|}} {{:​undefined:​img_1168.jpg?​nolink&​600|}} . {{:​research:​img_1167.jpg?​nolink&​600|}} . {{:​research:​img_1166.jpg?​nolink&​600|}}