Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
research:diy_stereo_bar [2018/04/09 16:58] – mrkva | research:diy_stereo_bar [2018/04/09 17:08] (current) – mrkva | ||
---|---|---|---|
Line 17: | Line 17: | ||
- Drill the three holes in the top rail. For 3/8" you can use 9mm drill bit on the sides and 10mm on the central one. On the sides, the closer to the internal diameter of 3/8" you'll get, the better. | - Drill the three holes in the top rail. For 3/8" you can use 9mm drill bit on the sides and 10mm on the central one. On the sides, the closer to the internal diameter of 3/8" you'll get, the better. | ||
- Screw in the screws into the holes and use thumbwheels as washers, protecting the screws from falling out. Alternatively you can use M8 retaining rings for shafts. | - Screw in the screws into the holes and use thumbwheels as washers, protecting the screws from falling out. Alternatively you can use M8 retaining rings for shafts. | ||
- | - Use the third thumb wheel as a way to tighten the bar to your stand. | + | - Use the third thumb wheel as a way to tighten the bar to your stand. You can epoxy-glue the wheel to the bar to attach it permanently. |
| | ||
{{: | {{: |