Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
research:diy_stereo_bar [2018/04/09 16:39] mrkvaresearch:diy_stereo_bar [2018/04/09 17:08] (current) mrkva
Line 2: Line 2:
  
 **Ingredients:** **Ingredients:**
-  * unperforated DIN rail (available in electrical supply stores)+  * unperforated, zinc-plated steel DIN rail (available in electrical supply stores or [[https://www.tme.eu/gb/details/ts35_7.5-1m/rail-mounted-connectors/|TME]])
   * 2 K&M 3/8" thumb screws (available on [[https://www.thomann.de/intl/km_raendelschraube.htm|Thomann]])   * 2 K&M 3/8" thumb screws (available on [[https://www.thomann.de/intl/km_raendelschraube.htm|Thomann]])
   * 3 K&M 3/8" thumb wheel (available on [[https://www.thomann.de/intl/km_raendelscheibe_alu_sw.htm|Thomann]]   * 3 K&M 3/8" thumb wheel (available on [[https://www.thomann.de/intl/km_raendelscheibe_alu_sw.htm|Thomann]]
Line 10: Line 10:
   * 9mm drill bit (but you can use a smaller one and extend it manually)   * 9mm drill bit (but you can use a smaller one and extend it manually)
  
-{{:research:img_1163.jpg?nolink&600|}}+**Total cost~6€**
  
-  - Adjust the size of the rail to your liking. For a 40 cm AB stereo bar I went with 42.5 cm +{{:research:img_1163.jpg?nolink&800|}} 
-  - Drill the three holes in top the rail. For 3/8" you can use 9mm drill bit on the sides and 10mm on the central one + 
-  - Screw in the screws into the holes and use thumbwheels as washers protecting the screws from falling out +  - Adjust the size of the rail to your liking. For a 40 cm AB stereo bar I went with 42.5 cm. 
-  - Use the third thumb wheel as a way to tighten the bar to your stand+  - Drill the three holes in the top rail. For 3/8" you can use 9mm drill bit on the sides and 10mm on the central one. On the sides, the closer to the internal diameter of 3/8" you'll get, the better. 
 +  - Screw in the screws into the holes and use thumbwheels as washersprotecting the screws from falling out. Alternatively you can use M8 retaining rings for shafts. 
 +  - Use the third thumb wheel as a way to tighten the bar to your stand. You can epoxy-glue the wheel to the bar to attach it permanently.
      
-{{:research:img_1165.jpg?nolink&600|}} . {{:research:img_1167.jpg?nolink&600|}} . {{:research:img_1166.jpg?nolink&600|}}+{{:undefined:img_1168.jpg?nolink&600|}} . {{:research:img_1167.jpg?nolink&600|}} . {{:research:img_1166.jpg?nolink&600|}}